Cleaning And Maintenance; Troubleshooting - Hyundai VKC 751 Instruction Manual

13) An automatic safety boil-dry cut-out has been fitted for protection against overheating: It will
also operate if the kettle is switched on when containing insufficient water. Always ensure the
water inside the kettle covers the minimum mark on the water level indicator gauge. If the
cut-out has operated, switch the kettle off, disconnect from the power outlet and allow the
kettle to cool down for 5 to 10 minutes. Then refill with enough water and switch on; the kettle
will then boil and cut off as in normal operation.

Cleaning and Maintenance

1) Unplug the kettle and wait until it cools down completely before cleaning or storing.
2) To avoid the risk of electric shock, do not clean the exterior of the unit, its base or its power
cord with water, and do not immerse it in water. The exterior of the kettle may be cleaned with
a slightly damp non-abrasive lint-free cloth without additives.
3) In the hard water area, it is important to do the decalcification regularly to keep the kettle in
good working condition, because too much scale inside may cause the kettle fail to work.
For the best performance of your kettle, decalcify the unit from time to time. The frequency
depends on the hardness of your tap water and how many times you have used the kettle.
Decalcification will clean the interior of the unit.
This may be done in the following manner:
- Half fill the kettle with ordinary tap water.
- Add 30 ml of white vinegar to the water in the kettle.
- Boil the mixture and allow it to stand for 30 seconds.
- Repeat this process two or three. Empty, rise well and use the kettle in the normal way.

Troubleshooting

The device is not working
• Check that the mains connection cable is firmly plugged in.
• Check the right possitions of the kettle on the base.
• Check the positions of the switches.
ENG - 20