How To Silence An Alarm And Reset The System - Honeywell ADE ACCENTA Gen4 User Manual

How to
Silence
an
Alarm··~
User Guide
LED Keypad:
The
til
LED should be on.
Enter your code [0][1][2][3]. The exit beep starts.
Press the CD key. The exit tone stops and the zone LEDs lto 3
come on.
Select part-set program [2] or [3]. The system sets after a
short time. The
til
LED goes out.
NOTE: There are no exit beeps if Silent Timed exit mode has been
programmed.
©sos
©.-"
I
@1iI
(6)~~(~~~
O'@
::.
[0][1][2][3] then CD
I
I
[2 or 3]
I
12345678
©©©©©©©© O'@
_ _ _ _ ©sos
"'~
©.-"
©1iI
How to Silence an Alarm and Reset the System
If your system goes into alarm then be aware that intruders may
be in the premises. Seek assistance before investigating the
cause of the alarm.
LCD Keypad:
Enter your code [0][ 1 ][2][3]. The alarm stops.
The screen alternates, showing what caused the alarm and
prompting for user reset.
When two or more alarms have occured, the first alarm
has an F below the zone number, Tamper or PA.
Subsequent alarms will have a 1 indicating where the
alarm has taken place.
Press
0.
The system resets and displays the date and time
if there are no open Tampers, PA or Fire zones to cause a
fault lockout.
The system can be reset by the user only if the installer
has programmed it to do so. If the message Engineer
Restore Required appears on screen then the user must
contact the installer.
After 30 seconds the system displays the date and time.
6
Enter Your Code
I
[0][1][2][3]
Res~ored
by User
Sunday Oi-Jan
14:10