How To Do A Walk Test - Honeywell ADE ACCENTA Gen4 User Manual

How to do a Walk Test
User Guide
How to do a Walk Test
Walk around your property, and in tum cause each detector to go into alann. Also, open and close
all door and windows that are protected by the system. For each detector (including door or window
sensor) that is activated the system produces a series of beeps, and the associated zone is indicated on
the keypad.
NOTE: Do not test any Personal Attack, Fire or Tamper keys during the Walk Test since these are
still active and will cause a full alarm.
If any ofthe tests fail, or you are unsure of the correct procedure, contact your installer
CD then [0][11[2][3]
LCD Keypad:
Press CD and then enter your code [0][l][2][3]. The
00
LED goes off to indicate that you are in Programming mode.
The first menu Walk Test appears on the screen.
00r[0]
Press 0 or [0]. Zones 1-8 have a zero (0) below each
TP
number.
00
I
When a zone is successfully tested, number 1 replaces the O.
®
Zones are added to the list as each one is activated. I
l0>wal.k Test
Press
®
to leave the menu or 0 to restart the Walk Test.
LED keypad
Press CD and then enter your code [0][1][2][3]. The
00
LED
CD then [0][1][2][3]
goes off and the./' LED comes on to indicate that you are
in Programming mode, Walk Test.
12345678
@@@@@@@@ o@
--"~--@SO$
@....
Press 0 or [0]. Zones 1-8 are off.
I
@Ol
o
When a zone is sucsessfully tested, the LED is on.
Zones are added to list as each one is activated.
Press
®
to leave the menu or 0 to restart the Walk Test.
18