Service And Maintenance; Accessories - Festool TSC 55 REB Original Operating Manual

TSC 55 REB
GB

Push down the machine slowly to the preset
cutting depth and then push forwards in the cut-
ting direction.
The markings [10-1] indicate the absolute front
and the absolute rear cutting points of the saw
blade (dia. 160 mm) when using the saw at maxi-
mum cutting depth with the guide rail.
8.6 Gypsum and cement-bound fibreboards
Due to the high volume of dust, it is recommended
to use the cover ABSA-TS55 (accessories) which
can be mounted at the side at the protective cover
and a Festool mobile dust extractor.
9

Service and maintenance

WARNING
Risk of injury, electric shock

Always disconnect the battery pack from the
machine before any maintenance or care work!

All maintenance and repair work which requires
the motor housing to be opened, must only be
carried out by an authorised service workshop.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
EKAT
Use only original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1
Observe the following instructions:

To ensure constant air circulation, always keep
the cooling air openings in the housing clean
and free of blockages.

Use an extractor on all the openings of the ma-
chine to remove wood chips and splinters.

Keep the contacts on the machine, charger and
battery pack clean.
24
Information on battery packs
– Store in a cool, dry place at a temperature be-
tween 5 °C and 25 °C.
– Protect battery packs from moisture, water and
heat.
– Do not leave flat battery packs in a charger dis-
connected from the mains power supply for lon-
ger than one month. Danger of deep discharge!
– If you intend to store li-ion battery packs for lon-
ger periods without use, you should charge them
to 40 % capacity (approx. 15 min charging time).
9.1 Resharpened saw blades
The cutting depth of resharpened saw blades can
be adjusted accurately using the adjusting screw
[11-1].

Adjust the cutting depth stop [11-2] to 0 mm
(with guide rail).

Unlock the saw unit and push downwards until
it reaches the stop.

Turn in the adjusting screw [11-1] until the saw
blade touches the workpiece.
10

Accessories

Always use accessories and consumable materials
approved by Festool. See Festool catalogue or
www.festool.com.
The power tool may become unsafe and lead to se-
rious accidents if other accessories and consum-
ables are used.
In addition to the accessories described, Festool
also provides a comprehensive range of system ac-
cessories that allow you to use your machine more
effectively and in diverse applications, e.g.:
• Parallel stop, table widener PA-TS 55
• Side-mounted cover, false joint ABSA-TS 55
• Kickback stop FS-RSP
• Parallel stop FS-PA and guide extension FS-PA-
VL
• Multifunction table MFT/3
10.1 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all applica-
tions that are specially designed for your Festool
portable circular saw.
10.2 Guide system
The guide rail enables you to make clean, accurate
cuts while simultaneously protecting the surface of
the workpiece from damage.