Lipo Battery Charging; Get The Helicopter Ready For Takeoff - Carson EASY TYRANN HORNET 350 Instruction Manual

LIPO BATTERY CHARGING

Important: Please only use the charger that was included to
charge the battery. Please follow the instructions in the manual.
Switch the model and the transmitter off.
Charging via USB:
1. The supplied LiPo battery is stored in the body of the helicopter.
2. Connect the USB charging cable to the helicopter's charging
socket.
The control light on the USB plug glows red during the charging
process. The light goes out once charging has finished.
Do not leave the copter or the charger unattended during the
charging process and always disconnect the battery from the
charger after completion! While charging, place the battery and
charger on a fireproof base!
Charging time: 2,5 h

GET THE HELICOPTER READY FOR TAKEOFF

Now we're good to go! But before liftoff, make sure that you have read this manual through completely.
1
Push the throttle lever fully down and then switch on the trans-
mitter.
3
Unlock push 3 sec or press button for takeoff/landing .
Now the helicopter is ready to launch.
GB // 18
ON/
OFF
2
Now connect the battery to the helicopter. Switch the helicopter on
and place it on a level surface.
ON/OFF