Table of Contents
Advertisement
Useful Information
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message
Check Phone Line
Error
Failed
Incomplete
Memory Full
No link to base.
Reconnect AC
adaptor.
Use rechargeable
battery.
You must first
subscribe to
Caller ID.
38
Cause/solution
L The supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 9).
L Recording was too short. Try again.
L Phonebook copy failed (page 18). Confirm the other
handset (the receiver) is in standby mode and try
again.
L The receiver's phonebook memory is full. Erase the
unnecessary phonebook entries from the other
handset (the receiver) and try again.
L The phonebook memory is full. Erase unnecessary
entries (page 17).
L Message memory is full. Erase unnecessary
messages (page 29).
L The call barred list memory is full. Erase unnecessary
entries (page 22).
L The handset has lost communication with the base
unit. Move closer to the base unit and try again.
L Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L The handset's registration may have been cancelled.
Re-register the handset (page 23).
L A wrong type of battery such as Alkaline or
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 3, 6.
L You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
Advertisement
Table of Contents
