Route Planning Method Types; Navigation Mode; Road Types - Alpine X701D/INE-W997D Owner's Manual

To reset all vehicle
, and

4.3.1.2 Route Planning Method types

You can select from the following route planning method types:
Button
Depending on the vehicle type, some methods may not be available.

4.3.1.3 Navigation Mode

You can switch between on-road and off-road navigation by tapping
selecting

4.3.1.4 Road types

To let the route fit your needs, you can also set which road types are to be considered for or
to be excluded from the route.
Excluding a road type is a preference. It does not necessarily mean total prohibition. If your
destination can only be accessed using some of the excluded road types, they are used only
as much as necessary. In this case, a warning icon is shown on the Route information screen,
and the part of the route not matching your preference is displayed in a different colour on the
map.
Some road types are only available in certain regions.
The following road types are available:
profiles to their
Gives a quick route if you can travel at or near the speed limit on all
roads. Usually, the best selection for fast and normal cars.
Results in a route with fewer turns and no difficult manoeuvres. With
this option, you can make Alpine Navigation System take, for example,
the motorway instead of a series of smaller roads or streets.
Gives a short route to minimise the travel distance. It can be optimal for
slow vehicles. Searching for a short route regardless of the speed, this
route type is rarely optimal for normal vehicles.
Gives a quick but fuel-efficient route based on the fuel consumption
data. Travel cost and CO
They cannot take elevations, curves and traffic conditions into
consideration.
Combines the benefits of Fast and Short. Alpine Navigation System
calculates as if it were calculating the Fast route, but it takes other
roads as well to save fuel.
or
default settings, tap
.
Description
emission calculations are estimations only.
2
(page 51).
,
and