Switching To Off-Road Navigation; Selecting The Destination In Off-Road Mode; Navigating In Off-Road Mode - Alpine X701D/INE-W997D Owner's Manual

3.8.1 Switching to off-road navigation

To switch to off-road navigation, perform the following steps:
1. Press the navigation hardkey button, and tap
2. Tap
Most of the procedures described for on-road navigation also apply to off-road navigation.
However, there are some that are not available in this navigation mode. For example:

You cannot open the itinerary as you have no manoeuvres just route points and
straight lines between them.

There are no route alternatives and route planning method.

Vehicle settings are disabled.

3.8.2 Selecting the destination in off-road mode

Selecting a destination (waypoint or final destination) is the same as described in the previous
sections. The only difference is that route points are linked to form a route with straight lines
regardless of the road network and traffic regulations.

3.8.3 Navigating in off-road mode

The real difference between on-road and off-road modes is the navigation itself. When you
are on the Navigation view with an off-road route:

Your position and heading is not aligned to the nearest road.

There is no turn-by-turn navigation, just a recommended direction.
You can see an orange line drawn between your current position and the next destination to
reach. The Turn Preview field in the top left corner shows a compass with your bearing and
the distance of the next destination.
When you reach the final destination, the navigation ends.
If you do not want to use off-road navigation, switch back to on-road navigation by
Note!
tapping
and select
and
52
, and .
.
.