Table of Contents
Advertisement
CONTROLS: OTHER BUTTONS
PRESET BANK
There are six available user presets that are in two banks. The bank can
be switched by pressing the
PRESET BANK
selected, pressing the corresponding footswitches will select presets
, or
. When preset bank B is selected, the footswitches select presets
2
3
, and
. The indicator lights (
s) above each footswitch will be green
5
6
LED
for bank A and red for bank B.
Bank A
1-3
PRESET BANK
HH ENABLE
The Hot Hand enable button enables or disables Hot Hand control for the
selected preset. This way, Hot Hand control can be set up for an individual
preset and can be left off otherwise.
CALIBRATE
Pressing this button when the pedal is engaged will turn on calibration
mode. Calibration mode allows you set a zero point for an attached Hot
Hand sensor. Calibration can only be enabled when
HH ENABLE
BACKPAGE
MODE
CALIBRATE
12 | Controls: Other Buttons
button. When preset bank A is
,
1
,
4
Bank B
4-6
HH ENABLE
is on.
CONTROLS: FOOTSWITCHES
There are three footswitches on the
MWB
footswitches correspond to presets
1
and
for bank B. Pressing any of the buttons will engage a given preset.
6
Pressing the footswitch for the currently engaged effect will put the unit
into bypass mode. Pressing another switch will engage that effect without
going into bypass.
The indicator lights above the three footswitches are bi-color and will
11
10
change depending on which bank is selected. Bank A presets are green
09
MULTI BAND
08
while bank B presets are red. When a preset is edited, the
07
to blink occasionally to show that the preset has been changed. When a
06
FOLDBACK
0
FULL
EQ AMOUNT
05
preset has been edited, pressing and holding any of the switches will save
04
the changes to the corresponding preset. The
03
NORMAL
02
indicate that the preset has been saved. Once changes are saved, the
01
00
will be lit solidly. See the Preset Saving section for other saving options.
CLEAN BOOST / EQ
DRIVE
(NG) (HG) (HS) (HA) (HR)
+12
Note: Changes made to a preset will be lost if you go into bypass or
0
switch to another preset without saving!
1-3
4-6
-12
62 125 250 500 1K
<
PRESET BANK
1
4
MULTIWAVE BASS DISTORTION
2
Pro. From left to right, the
,
, and
for preset bank A and
,
,
2
3
4
5
OCTAVE
12
13
14
will begin
LED
15
NORMAL
16
0
17
CLEAN MIX
FOLDBACK
18
will blink quickly to
LED
SINGLE BAND
19
20
LED
21
OCTAVE
22
0
DISTORTION MIX
+12
0
HH ENABLE
BACKPAGE
-12
MODE
2K
4K
>
CALIBRATE
3
6
5
Controls: Footswitches | 13
Advertisement
Table of Contents
Need help?
Do you have a question about the Soundblox Pro and is the answer not in the manual?