Table of Contents
Advertisement
Setting up network printing
4.5
LPR printing
The LPR print service is supported as standard in Windows 2000, Windows
XP, Windows NT 4.0, and Windows Server 2003. TCP/IP is used as the net-
work protocol.
Operations on this machine
Set the IP address for this machine. For the setting procedure, refer to "Set-
ting the IP address for this machine" on page 4-8.
Printer driver settings
For Windows 2000/XP/Server 2003
1
For Windows 2000, click the [Start] button, point to "Settings", and
then click "Printers".
For Windows XP/Server 2003, click the [Start] button, and then click
"Printers and Faxes".
–
If "Printers and Faxes" does not appear in the Start menu, open the
Control Panel from the Start menu, select "Printers and Other Hard-
ware", and then select "Printers and Faxes".
2
Right-click the icon of the installed printer, and then click "Properties".
3
On the Ports tab, click the [Add Port] button.
4
In the "Available Printer Ports" list, select "Standard TCP/IP Port", and
then click the [New Port] button.
5
When the Add Standard TCP/IP Printer Port Wizard starts up, click the
[Next] button.
6
In the "Name of printer or IP address" box, enter the IP address for this
machine, and then click the [Next] button.
7
Select "Custom", and then click the [Settings] button.
8
Select "LPR", enter "Print" in the "Queue Name" box, and then click the
[OK] button.
9
Click the [Next] button, and then click the [Finish] button to apply the
setting.
–
If "LPR Byte Counting Enabled" is not selected, the data may not
be printed.
200/250/350
4
4-15
Advertisement
Table of Contents
