HP 7 G2 1311 Maintenance And Service Manual page 26

1. Disconnect the following cables from the system board:
(1) Front-facing webcam cable (see
(3) Power/volume button board cable (see
(4) Release the ZIF connector to which the display panel cable is attached, and then disconnect
the display panel cable from the system board
(5) Release the ZIF connector to which the TouchScreen cable is attached, and then disconnect
the TouchScreen cable from the system board
(6) Speaker cable (see
2. Remove the two Phillips PM1.4×2.75 screws (1) that secure the system board to the
display panel assembly.
20 Chapter 5 Removal and replacement procedures
Front-facing webcam on page
Power/volume button board on page
Speaker on page 15)
17)
18)