Noise / Vibration Information; Application; Activation - Protool CHP 26 PLUS Original Instruction

- Switch the power tool off immediately if
the tool insert gets jammed. Be prepared
for high torque levels if the tool kicks
back. The tool insert jams if:
- the power tool becomes overloaded or
- the tool tilts in the workpiece
- To mark the machine, do not drill into the
housing. The protective insulation would
be bridged. Use stickers.
- Never use the machine with a damaged
cable. Do not touch the damaged cable and
pull the mains plug when the cable gets
damaged during operation. Damaged ca-
bles increase the risk of electric shock.
Sliding clutch
- Always assume a safe standing position
and hold the power tool securely in both
hands. If the drill jams unexpectedly, the
machine kicks back.
- If the tool insert becomes caught or is
jammed, the drive to the drill spindle is
interrupted. Remove the load from the
machine immediately by retracting the
drill.
WARNING
If the power tool jams, switch the
machine off and release the tool in-
sert. When switching the machine on
with the drilling tool jammed, high
reaction torques can occur.
Residual risk
Although this information sheet and the
operating manuals for our electrical tools
contain extensive instructions on safe work-
ing with electrical tools, every electrical tool
involves certain residual risks that cannot
be completely prevented through safety
mechanisms. Therefore, electrical tools
must always be operated with the neces-
sary caution.

4.7 Noise / Vibration Information

Measured values determined according to
EN 60 745.
Typically the A-weighted noise levels of the
tool are:
Sound pressure level: 91 dB (A).
Sound power level: 102 dB (A).
Inaccuracy of measurement K = 3 dB (A).
CAUTION
The noise created during work may
damage hearing.
► Use hearing-protective aids!
The typical hand-arm vibration is below
24.2 m/s .
2
Inaccuracy of measurement K = 2.5 m/s
The typical hand-arm vibration is below
18.6 m/s .
2
Inaccuracy of measurement K = 1.5 m/s
Declared total value of vibrations was
measured according to standard measure
method and can be used for comparison
one powertools with the others.
Declared total value of vibrations can be
used for preliminary setting of exposition.
Warning:
Emission of vibrations during real operating
can be different from declared total value of
vibrations depending on specifi c real condi-
tions.
To protect operating person shell be provide
safety measurement, that evaluate the ex-
position under the real conditions (here are
included all parts of operating cycle, switch
of mode and idle run mode).
5

Application

The rotary/chiseling hammer can be used
universally for impact drilling, for light chis-
elling work in masonry and for drilling as well
as screwdriving in wood, metal and plastic.
This product does not fall under the com-
petency of directive 00/14/EC, article 12,
point 4.
6

Activation

WARNING
Before performing any maintenance
work on the tool, always remove the
plug from the electrical mains socket.
Check that the information on the manufac-
turing label complies with the actual power
supply voltage.
.
2
.
2
15