Adjusting The Steering Cable Tension - Mercury motorguide X5-55 Operation, Maintenance & Installation Manual

2. Install the propeller onto the motor shaft by engaging the propeller onto
the propeller pin.
3. Install the washer (or anode, for saltwater models) onto the propeller
shaft, then install the propeller nut. Use a wrench or a socket and ratchet
to tighten the propeller nut until it is snug, then tighten the nut another 1/4
turn.
IMPORTANT: Do not overtighten the propeller nut, or damage to the propeller
or propeller pin may occur.

Adjusting the Steering Cable Tension

Neglecting to inspect, maintain, or repair your trolling motor can result in
product damage or serious injury or death. Do not perform maintenance or
service on your trolling motor if you are not familiar with the correct service
and safety procedures.
The cable tension on the X5 trolling motor is preset at the factory. With time
and use, the cables may stretch slightly, requiring occasional adjustment. The
following procedure explains how to adjust the steering cable tension.
Use care while adjusting the steering cable tension. Excessive cable tension
will cause premature wear to the cables and pulleys, while excessively loose
tension may cause the cables to jump off of the pulleys, resulting in a loss of
steering control.
eng
MAINTENANCE
WARNING
!
29
57326
53442