Mercury motorguide X5-55 Operation, Maintenance & Installation Manual page 37

IMPORTANT: Do not release the latch release handle until the new locking pin
is installed, or internal damage to the mount will occur.
a
3. Once the lock is aligned as shown, press the locking pin in the direction
indicated, but do not remove it completely.
NOTE: If required, tap the locking pin out with a screwdriver handle or small
hammer to disengage the locking pin.
4. Continue to hold the latch release handle once the locking pin is partially
removed.
5. Orient the new locking pin so the alignment tab is facing the same
direction as the alignment tab of the old locking pin.
6. Press the new locking pin into the opposite side of the mount. Continue to
press the new locking pin until it clicks into position.
eng
MAINTENANCE
b
58757
a - Locking pin
b - Lock
58758
31