Table of Contents
Advertisement
WIRING AND BATTERY INFORMATION
Wiring and Battery Information
An operating or charging battery produces gas that can ignite and explode,
spraying out sulfuric acid, which can cause severe burns. Ventilate the area
around the battery and wear protective equipment when handling or servicing
batteries.
Performing service or maintenance without first disconnecting the battery can
cause product damage, personal injury, or death due to fire, explosion,
electrical shock, or unexpected motor starting. Always disconnect the battery
cables from the battery before maintaining, servicing, installing, or removing
motor components.
Standard Practices and Procedures
When installing or removing this trolling motor, follow these guidelines:
•
Disconnect the trolling motor from the trolling motor battery.
•
Do not use the main engine battery to power the trolling motor.
Battery Recommendations
•
Use 12‑volt, deep cycle marine batteries. The number of batteries
required varies according to the model of your trolling motor. Refer to
Battery Connection.
•
As a general rule, deep cycle batteries with a higher amp‑hour rating or
reserve capacity rating will provide longer run times and better
performance.
•
Install a manual reset circuit breaker in line with the trolling motor positive
leads within 180 cm (72 in.) of the batteries. These can be purchased
from your local MotorGuide retailer or from www.motorguide.com.
•
Do not extend the included 10‑gauge battery cables more than 1.8 m (6 ft)
for a total of 3 m (10 ft). If longer battery cables are required, MotorGuide
offers accessory 8 mm² (8‑gauge) battery cables.
•
Use nylock nuts to secure the battery cables to their terminals. Using wing
nuts to secure the battery cables can cause loose connections.
•
Any depth sounders or fish finders must be powered from the engine
starting battery. Connecting electronic equipment to the trolling motor
batteries can cause electrical interference and possible electrolysis.
Recommended MotorGuide Accessory Description
8‑gauge battery cable and terminals with 50‑amp
manual reset circuit breaker
eng
WARNING
!
WARNING
!
7
Part Number
MM309922T
Hide quick links:
Advertisement
Table of Contents
