Assembly - NordicTrack NTE13920 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a phillips screwdriver
wrenches
As you assemble the elliptical exerciser, use the drawings below to identify the small parts used in assembly.
The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on
pages 28 and 29. The second number refers to the quantity used in assembly. Note: Some small parts may
have been pre-assembled. If a part is not in the parts bag, check to see if it is pre-assembled.
M6 Washer
M10 Split
(64)–2 Washer (73)–2
M8 x 38mm Button
Bolt (105)–2
M8 x 44mm Button Screw (84)–8
M4 x 12mm M4 x 16mm
Screw (96)–1 Screw (98)–4
1. Identify the Front Stabilizer (8). While another person
lifts the front of the Frame (1) and holds the Pedal
Legs (4, 5) in the position shown, attach the Front
Stabilizer to the Frame with four M8 x 44mm Button
Screws (84) and a Support Plate (104).
While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (not shown) to the Frame
in the same way.
, a rubber mallet
M10 Washer
(126)–2
M8 x 58mm Button Screw (83)–4
, and pliers
Spacer (109)–2
M8 Jam Nut
(86)–6
M10 x 78mm Bolt Set (65)–2
M10 x 110mm Button Screw (70)–2
1
1
104
84
5
, two adjustable
.
M6 x 16mm Patch
Screw (76)–4
M8 x 41mm Button
Bolt (85)–4
4, 5
8
84