N.asap Ii Seating Adjustment; O.seat Pan And Back Size Adjustments; Manual Recline Operation; Q.power Recline, Tilt & Lift Operation - Quickie QM-710 Owner's Manual

Q M- 7 1 0/7 1 5 HD/ 7 2 0
N. ASAP II SEATING ADJUSTMENT
Please refer to the ASAP Seating Adjustment Guide for details on how to adjust the seat
depth, seat width, armrest height and backrest angle.
Pre-tilt and Seat-to-floor height
20
Pre-tilt positioning:
• For 0º pre-tilt use hole positioning number (X) on the packer module.
• For 3º pre-tilt use hole positioning number (Y) on the packer module
• For 6º pre-tilt use hole positioning number (Z) on the packer module
21
Seat-to-Floor Height:
Seat-to-floor height is accomplished by using the same hole number on both the front and
rear posts when raising or lowering the seated position.
DO NOT Increase the front post height independent from the rear posts when providing
seating pre-tilt. Use only the Pre-tilt positioning holes on the Packer module (Figure 20).
NOTE– For chairs configured with SPOT tilt, do not increase the Pre-tilt greater than 3º.
For chairs configured with seat elevator, do not increase the pre-tilt greater than 0º.
For chairs configured with SPOT tilt and seat elevator do not increase the seat-to-floor
height greater than 1" from lowest position.
O. SEAT PAN AND BACK SIZE ADJUSTMENTS
Your ASAP II seating system can be adjusted to a wide range of widths and depths to accom-
modate specific user needs. Seating dimensions should only be altered by a trained profes-
sional and may require new seat cushions. Please refer to the QM-710/715HD/720 Service
Manual for more detailed instructions on how to customize the size of your seat.
P. MANUAL RECLINE OPERATION
The ASAP II seating system has two manual recline options. The first is using a 16mm socket
wrench at point (K) and the second can be done by using a knob (L) on the side of the chair.
To recline the chair, rotate this knob clockwise and turn the knob counter-clockwise to
return the back to a more upright position.
Q. POWER RECLINE, TILT & LIFT OPERATION
The power recline, tilt and lift features on your chair can all be operated using the joystick on
your chair. Follow the instructions below to operate:
1. Make sure your controller is on.
2. From the Drive Mode, press the Mode button to enter Power Seating Mode.
3. Move the joystick left or right selecting the power option (recline, tilt, lift, legrests) you
wish to control.
4. Move the joystick forward or backward to adjust the selected power option to the
desired position.
5. Press the Mode button to return to normal operation or continue moving the joystick
left or right to adjust the next power option. Multiple Mode button presses will be
necessary if other modules, such as Bluetooth or Output, are active.
118444 Rev. C
SEATING SYSTEM SET-UP
20 21 22
22
WARNING
SEATING SYSTEM ADJUSTMENT
23
18
XHole 0°
YHole 3°
ZHole 6°
Front
Post
1st Hole
2nd
3rd
4th
5th
6th
Rear
Post
1st Hole
2nd Hole
3rd Hole
4th Hole
5th Hole
6th Hole
K
VIII.
20
21
23
L