Quickie QM-710 Owner's Manual page 23

Q M-7 10 /715HD/7 20
Inhibit (Fig. 14)
If the speed of the wheelchair is being limited; for example, by a tilted seat, then this orange
symbol will be displayed. If the wheelchair is being inhibited from driving, then this red sym-
bol will be flashing.
–Mode Screens–
Actuator Mode (Fig. 15)
Displays the sections of the chair currently selected for movement, the name given to the
selection and a direction arrow showing what sort of movement is available.
Bluetooth Mode (Fig. 16)
When Bluetooth Mode is entered this screen will be displayed.
Speed Adjust (Fig. 17)
When Speed Adjust Mode is entered, this screen will be displayed momentarily.
MESSAGE WINDOW (Fig. 18)
The RNET displays warning icons and informational messages, in a dedicated message window.
Restart (Fig. 19)
When the control system requires a reboot; for example, after a module re-configuration,
this green symbol will be flashed.
Timer (Fig. 20)
This symbol is displayed when the control system is changing between different states. An
example would be entering into Programming Mode. The symbol is animated to show the
sands falling.
Sleep (Fig. 21)
This symbol will be displayed for a short time before the R-net enters into a sleep state.
Cross & Tick (Fig. 22)
These symbols will be displayed during configuration procedures.
Green Check: Process completed correctly
Red X: Process NOT completed correctly.
E-Stop (Fig. 23)
If the External Profile Switch is activated during drive, or actuator operation, this red symbol
will be displayed.
Joystick Displaced (Fig. 24)
If you operate the Joystick before or just after you switch the control system on, the screen
will flash the joystick displaced screen.
You must release and center the joystick to resume normal operation. If you do not release
the joystick within five seconds the wheelchair will not be able to move, even if you release
the joystick and operate it again. The screen will display a diagnostic screen at this time. You
can reset this condition by switching the control system off and on again.
MOMENTARY SCREENS (Fig. 25)
If the momentary screens are programmed to be displayed, then pressing the Speed or
Profile Buttons will display screens such as this.
DIAGNOSTIC SCREEN (Fig. 26)
When the control system safety circuits have operated and the control system has been pre-
vented from moving the wheelchair, a diagnostics screen will be displayed. This indicates a system
trip, i.e. the RNET has detected a problem somewhere in the wheelchair's electrical system.
23
IX.
14
15
16
17
18
19 20
21
22
23
24
25
26
118444 Rev. C