Set-Up, Adjustment And Use; Adjustment Notes; Tools You Might Need; C.check-Out - Quickie QM-710 Owner's Manual

Q M- 7 1 0/7 1 5 HD/ 7 2 0
A. ADJUSTMENT NOTES
1. Work Surface For Set-Up:
Use a flat surface, such as a table, to assemble, adjust and check your
chair. This makes the steps easier and helps ensure a correct set-up.
2. Fasteners:
• Many of the screws and bolts on this chair are special high-
strength fasteners and may have special coatings.
• Many nuts are of the Nylock type. They have a plastic insert
to help prevent loosening.
• Only use screws, bolts and nuts provided by Sunrise.
1. Use of improper fasteners may cause the chair to fail.
2. Over- or under-tightened fasteners may fail or cause damage
to chair parts.
3. If bolts or screws become loose, tighten them as soon as
you can. Loose bolts or screws can cause damage to other
chair parts causing them to fail.
3. Washers & Spacers:
• Note the position of washers and spacers before disassem-
bly.
• To avoid damage to the frame, replace all washers and spac-
ers when you reassemble parts.
4. Torque Settings:
• A torque setting is the optimal tightening for a particular fas-
tener. Use a torque wrench that measures inch-pounds to
secure screws, nuts and bolts on this chair.
B. TOOLS YOU MIGHT NEED
1. Basic Tool Kit:
To set-up, adjust and maintain your chair you may need the
following tools:
• Combined Phillips and flat screw driver
• Standard metric wrenches from 8mm - 14mm
• Metric Allen wrenches from 2mm - 5mm
• Imperial wrenches from 1/4" to 9/16"
• Imperial Allen wrenches from 5/64" to 1/4"
You can obtain a multi-purpose tool kit from Sunrise, or buy the
tools you need from a hardware store.
C. CHECK-OUT
Be sure this chair performs to your chosen operational settings. If it
does not, turn the chair off immediately and have the dealer repro-
gram.
Q-NOTE– Repeat this procedure until the chair performs to your
specifications
When properly set-up, this chair will operate smoothly. Check to
see that all components work properly. If you detect a problem, be
sure to correct it before use.
118444 Rev. C
WARNING
WARNING
VIII. SET-UP, ADJUSTMENT AND USE
D. BATTERY REMOVAL
To remove the batteries for transporting or servicing:
Remove Batteries
a. Remove the two knobs (A) securing the seat. Tilt the entire
seat back until it rests on the stop.
b. Remove the shroud cover by lifting up on it as shown.
c. Disconnect both battery harnesses (red & black connectors).
d. Lift the battery from the compartment via the battery carry-
ing straps.
Batteries may weigh up to 55 lbs. (25 kg). Care must be taken to
avoid injury when lifting.
14
1 2 3 4
WARNING
1
A
2
3
4