SiBE041012_A
4. Field Settings
4.1
When 2 Units are Installed in 1 Room
When 2 indoor units are installed in 1 room, 1 of the 2 pairs of indoor unit and wireless remote
controller can be set for different address.
Both the indoor unit PCB and the wireless remote controller need alteration.
Indoor Unit PCB
1) Remove the front panel and front grille. (4 screws)
2) Cut the address setting jumper (JA) on the signal receiver / display PCB.
Wireless Remote
(1) Remove the cover and take it off.
(2) Cut the address setting jumper.
Controller
Trial Operation and Field Settings
(Bottom of electrical box)
Jumper
Address
EXIST
1
CUT
2
(R14631)
Field Settings
(R12036)
222