Setting The Base; Changing The Base Gigaset S810A Ringtones; Activating/Deactivating Music On Hold; Repeater Support - Gigaset S810 Manual

Setting the base

Setting the base
The base settings are carried out using a reg-
istered Gigaset S810H handset.
Changing the base
Gigaset S810A ringtones
u
Volume:
You can choose between five volumes
(0–6; e.g., volume 3 = Š) and the "cre-
scendo" ringtone (6; volume increases
with each ring = ‡).
u
Ringtones:
You can select a ringtone from a list of
pre-loaded melodies.
In idle status:
Ï
¢ ¢
v
Audio Settings
¢
Ringtones (Base)
¤
You can enter data in the following fields:
r
Set volume.
s
Scroll to the next line.
r
Set melody.
§Save§
Press the display key to save the
setting.
•
Activating/deactivating
music on hold
Ï
¢ ¢
v
Audio Settings
¢
Music on hold
§Change§
Press to activate or deactivate the
music on hold (³ = on).
76
•

Repeater support

With a repeater, you can increase the range
and signal strength of your base. You will
need to activate repeater mode. This will ter-
minate any calls that are in progress at the
time.
Prerequisite: A repeater is registered.
Ï
¢ ¢
v
System
§Change§
Press to activate or deactivate
repeater mode (³= on).
After activating or deactivating the
repeater, switch your handset off and
¢
on again (
page 23)
Please note
u
Eco Mode / Eco Mode+ (
and repeater support cancel each
other out, i.e., if you use a repeater,
you cannot use Eco Mode or Eco
Mode+.
u
Encrypted transmission activated at
the factory is deactivated when a
repeater is registered.
¢
Repeater Mode
.
¢
page 59)