Connections - Funkwerk bintec R230A Technical Data Manual

3
bintec R232b
22 bintec User's Guide
In operational mode the LEDs display the following status information:
LED Status
Power on
Status on
flashing
1 to 4 on
flashing
ETH on
flashing
ADSL on
ISDN on
flashing
Table 3-2: LED status display
3.4

Connections

All connections are located on the rear of the gateway.
fers a 4-port Ethernet switch, an ETH interface, an ISDN interface, an
ADSL interface as well as a serial interface.
Information
Power supply has been connected.
The gateway is booting.
The gateway is active.
The gateway is connected to the Ethernet
(100 Mbit/s or 10 Mbit/s respectively).
Data traffic via the Ethernet interface (100
Mbit/s or 10 Mbit/s respectively).
The gateway is connected to the Ethernet.
Data traffic via the Ethernet interface.
ADSL connection is active.
One B-channel is used.
Both B-channels are used.
bintec R232b of-
Technical Data