Table of Contents
Advertisement
First time installation
General information
Once you have correctly connected the Mediamaster, you will also have to perform
a "First-time installation." During this procedure, helpful information is displayed
at the bottom of the menus.
Please note!
The select button always confirms a selection within these menus, and pressing
it will take you to the next step in the installation process. However, and this is im-
portant, more than one value often has to be entered in a menu. Firstly, make all
necessary setting changes. Then, confirm them all simultaneously by pressing
select.
You can always return to the previous menu by pressing back.
Use the cursor up/cursor down button to move upwards and downwards from
one line to another.
Use the cursor left/cursor right button to change settings.
You can also use the numeric buttons on the remote control to enter numeric val-
ues.
The "First-time installation" menu
This picture indicates that you have started the installation procedure.
• Plug in your Mediamaster.
• The "First-time installation" menu is shown.
• Press select to continue.
Language
• Select the desired menu language using the cursor up/cursor down button.
This will also become the main language for audio and subtitling.
• Press select to continue.
Antenna/satellite selection
• Select the "One antenna/one LNB configuration" alternative if you have a sin-
gle antenna equipped with one LNB for receiving signals.
• Select the alternative "Multisatellite/DiSEqC switch configuration" alternative
if you have one antenna with two or four LNBs or two antennas with one or two
LNBs each for receiving signals from a combination of satellites. In this cases
you will need a 2-way or a 4-way DiSEqC switch.
• Select the "Motor antenna configuration" alternative if you have an antenna mo-
tor to control your satellite antenna.
GB 14
Advertisement
Table of Contents
