Nokia DNT2Mi sp/mp Operating Instructions Manual page 45

DN01145897
Issue 2-0 en
Table 5. Global parameters (Continued)
Use of front panel keys
Q1 rate *)
*) = Recalling the default values does not change the values set for the Q1
management parameters. The original values for these parameters can be recalled by
recalling the factory settings, refer to Section 6.10.
Table 6. Line parameters
Line interface
Power backoff
Bit error alarm limit
Table 7. Multiplexer parameters
Use of time slots
Table 8. Port parameters, V-series (V.11, V.28, V.35 or EIA-530-A)
Port rate
Use of V.110 rate adaptation in
port 2 or 3
In port 2 or 3
Remote loop detection
Externally caused alarms
Rx timing (CT103)
CTS use
CTS
DCD
DSR
Circuit 140
Circuit 141
© Nokia Corporation
Nokia Proprietary and Confidential
In use
4800 bit/s
STU-R rate adaptive, 2-wire
ON
-6
10
No time slots connected
n x 64k (n=1)
Not in use
9600 kbit/s, Synchronous
Allowed
Disabled (not to be seen through Q1).
However, even if these alarms are disabled, they
cause front panel alarms.
DCE source (CT114)
Not in use
On
Follows line synchronisation
On
Disabled
Disabled
Commissioning DNT2Mi
45 (128)