Nokia DNT2Mi sp/mp Operating Instructions Manual page 109

DN01145897
Issue 2-0 en
- CTS use (6,4, port #,3,3,1)
The suboptions of the menu allow you to:
• display the current use of the circuits
• set the CTS (106) circuit ON
• make the CTS circuit follow the RTS (105) circuit with a 8-
bit delay in transition from the OFF state to the ON state
• make the CTS circuit follow the RTS circuit with a 255-bit
delay in transition from the OFF state to the ON state
• set the RTS circuit to control the DCD (109) circuit at the
remote end (Simulated carrier).
- DCD use (6,4, port #,3,3,2)
The suboptions of the menu allow you to:
• display the use of the DCD circuit
• set the DCD circuit to follow the synchronisation of the line
(frame sync on −> DCD on)
• set the DCD circuit to follow the simulated carrier signal
(V.13).
- DSR & DTR use (6,4, port #,3,3,3)
The suboptions of the menu allow you to:
• display the current use of the DSR (107) and DTR (108)
circuits
• set the DSR circuit to follow the state of the DTR circuit
• set the DSR circuit to ON state, the DTR circuit not being in
use.
- CT140 use (6,4, port #,3,3,4)
The suboptions of the menu allow you to:
• display the current use of circuit 140
• enable or disable circuit 140 to control the remote loop to line.
- CT141 use (6,4, port #,3,3,5)
The suboptions of this menu allow you to:
• display the current use of circuit 141
• enable or disable circuit 141 to control the local loop.
G.704/2M-type interface settings (6,4, port #,3)
• Framing format (6,4, port #,3,1)
The use of the G.704 framing can be selected or its use can be prevented
using this menu (see Figure 65). The selections are:
- No frame
- Basic frame
- CRC multiframe
© Nokia Corporation
Nokia Proprietary and Confidential
Using Q1 menus
109 (128)