Slide angled end of
the mounting bar
towards the rear panel
Lift DNT2Mi on
the bracket
5
Fasten the bracket into
wall with screws
3
28 (128)
Data Network Terminal Single-port and Multiport Operating Instructions
Mounting bar
1
Wall-mounting bracket
6
Mark fixing points on the wall using
the bracket as schema
Figure 13.
Installation of DNT2Mi on a wall
To install DNT2Mi on a wall:
1.
Position the mounting bar onto DNT2Mi.
•
Place DNT2Mi bottom-side up and slide the angled end of the
mounting bar towards the rear panel.
•
Ensure that the pin in the other end of the mounting bar locks into
the opening in the bottom of DNT2Mi.
© Nokia Corporation
Nokia Proprietary and Confidential
Fasten to DNT2Mi with
2
the screw included
4
Drill holes (
45 mm,
ø 6 mm drill bit) into
the wall
DN01145897
Issue 2-0 en