Free-Standing Installation; Installing Dnt2Mi On A Wall Or Into A Rack; Installing Dnt2Mi On A Wall - Nokia DNT2Mi sp/mp Operating Instructions Manual

5.6

Free-standing installation

5.7

Installing DNT2Mi on a wall or into a rack

5.7.1

Installing DNT2Mi on a wall

DN01145897
Issue 2-0 en
Note
A free-standing installation of DNT2Mi is allowed only if permitted by the local
electric safety regulations!
To install DNT2Mi free-standing:
1. Place DNT2Mi on a dry and clean horizontal level.
Caution
Make sure that the unit may not be dropped incidentally!
2. Guide the strain relief as advised in Figure 24.
3. Take care of the grounding as advised in Section 5.2.
This section gives instructions for the mechanical installation of DNT2Mi into a
19-inch rack or on a wall.
The mounting accessories used are:
• DS 62000.1 Modem shelf for low housing (single-port, 7 units)
• DF 62001.1 Wall-mounting bracket
• DF 62010.1 DC-power rail.
Note
When selecting an installation location, make sure that all cables can be easily
connected. See Figure 11 for adequate clearances.
© Nokia Corporation
Nokia Proprietary and Confidential
Installing DNT2Mi
27 (128)