Operation - HAKO Scrubmaster B30 Instruction Manual

First Operation
2.5

Operation

Scrubmaster B30
1. Switch the machine on at the main
switch. The suction turbine is
switched on.
2. Lower the squeegee using the
squeegee lever.
3. Lower the brush head using the foot
pedal.
4. Draw back the bar on the bail sys-
tem. The brush head drive and solu-
tion supply are switched on.
5. Set the solution quantity with the
hand valve.
6. Push the machine. The power flow of
the brush head drive supports the
forward drive.
Start driving immediately after
switching on the brush head
drive otherwise imprints of the
brush could be produced on
the floor. Raise the brush head
when driving over thresholds.
Scrubmaster B30 CL
1. Switch the machine on using the key
switch. All the units are in Standby
2. Lower the squeegee using the
squeegee lever. The suction turbine
is switched on.
3. Lower the brush head using the foot
pedal.
4. Pull the dead-man's switch on the
bail system. The brush head drive is
switched on.
5. Set the solution quantity using the
button on the operating panel.
6. Set the driving direction and speed
using the bail system.
7. To alter the cleaning intensity of the
cleaning process, use the buttons on
the operating panel to change the
solution quantity and switch the solu-
tion supply on and off.
Start driving immediately after
switching on the brush head
drive otherwise imprints of the
brush could be produced on
the floor. Raise the brush head
when driving over thresholds.
15