Bosch TES?515 Instruction Manual page 21

en
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use.
Cleaning
Duration: approx. 10 minutes.
If the message Clean required! appears
on the display, press the k off / i button
(13) for 3 seconds and then press the start
button (10).
The cleaning programme will start.
To clean the appliance before being
prompted, press the k off / i button (13) for
at least 3 seconds. Then press the k off / i
button (13) briefly twice. Turn the upper
rotary knob (15) until Start cleaning appears
in the display. To start the cleaning proce-
dure, press the start button (10). The display
will guide you through the programme.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Open drawer
● Open the drawer (4).
Fill cleaner
Press start
● Drop a Bosch cleaning tablet in the
drawer (4) and close.
● Press the start button (10).
Cleaning in progress
The cleaning pro gramme will now run for
about 8 minutes.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
The appliance has finished cleaning is
ready for use again.
Calc'n'Clean
Duration: approx. 35 minutes.
Calc'n'Clean combines the separate func-
tions of descaling and cleaning. If both
programmes are due to be run soon, the
espresso machine automatically suggests
this service programme.
Important: If there is a filter in the water
tank (17), it needs to be removed before the
service programme is run.
If the message Calc'n'Clean required!
appears on the display, press the k off / i
button (13) for 3 seconds and then
press the start button (10). The service
programme will start.
To run Calc'n'Clean before being prompted,
press the k off / i button (13) for at least
3 seconds. Then press the k off / i button
(13) briefly twice. Turn the upper rotary
knob (15) until Start Calc'n'Clean appears
in the display. To start Calc'n'Clean, press
the start button (10).
The display will guide you through the
programme.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Open drawer
● Open the drawer (4).
Fill cleaner
Press start
● Drop a Bosch cleaning tablet in the
drawer (4) and close.
● Press the start button (10).
N.B.: If the water filter is activated, the display
will prompt you to remove the filter and then
press the start button (10) again. Remove the
filter now if you have not already done so.
Press the start button (10).
17
TES515.. | 7/2014