If you want the caller's name to be spoken when your
device rings, select
to On. The caller's name must be saved in
To create a new profile, select
profile lets you use the device without
connecting to the wireless network. When you activate the
profile, the connection to the wireless network is
turned off, as indicated by
indicator area. All wireless RF signals to and from the
device are prevented. If you try to send messages, they are
placed in the outbox to be sent later.
profile is active, you can use your device
without a (U)SIM card.
Important: In the offline profile you cannot make or
receive any calls, or use other features that require cellular
network coverage. Calls may still be possible to the official
emergency number programmed into your device. To make
calls, you must first activate the phone function by
changing profiles. If the device has been locked, enter the
When you have activated the
use the wireless LAN, for example, to read your e-mail or
browse on the internet. Remember to comply with any
> Personalise, and set
in the signal strength
profile, you can still
applicable safety requirements when establishing and
using a wireless LAN connection. See 'Wireless LAN', p. 70.
You can also use Bluetooth connectivity while in the
profile. See 'Bluetooth connectivity', p. 72.
To leave the
profile, press the power key, and select
another profile. The device re-enables wireless
transmissions (providing there is sufficient signal
, and select
you can enable three-dimensional sound effects
for ringing tones. Not all ringing tones support 3-D effects.
To enable the 3-D effects, select
To change the 3–D effect that is applied to the ringing
modify the effect, select from the following settings:
speed—Scroll left or right to adjust the speed at
which sound moves from one direction to another. This
setting is not available for all ringing tones.
Reverberation—Select the type of echo.
3-D ringing tone
and the desired effect. To