Data Call - Nokia N81 User Manual

•
Pre-shared key (only for
password. The same password must be entered on the
wireless LAN access point device.
•
WPA2 only mode (only for WPA/WPA2)—Select
whether Temporal Key Integrity Protocol (TKIP) is used.
Homepage—Define a home page.
Select Options > Advanced settings
following:
IPv4 settings: Phone IP address
device), Subnet mask (the subnet IP address),
gateway (the gateway), and
addresses of the primary and secondary DNS server.
Contact your internet service provider for these addresses.
IPv6 settings > DNS address—Select Automatic,
known, or User defined.
Ad-hoc channel (only for Ad-hoc)—To enter a channel
number (1-11) manually, select
Proxy server address—Enter the address for the proxy
server.
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Pre-shared key)—Enter a
and from the
(the IP address of your
Default
DNS address. Enter the IP
Well-
User defined.
Packet data connection—If you select
and you are in a network that supports packet data, the
device registers to the packet data network. Starting an
active packet data connection (for example, to send and
receive e-mail) is quicker. If there is no packet data
coverage, the device periodically tries to register to the
packet data network. If you select
device uses a packet data connection only if you start an
application or action that needs it.
Access point—The access point name is needed to use your
device as a packet data modem to your computer.
Wireless LAN
Show WLAN availability—Select whether
when a wireless LAN is available.
Scan for networks—If you set
Yes, select how often the device searches for available
wireless LANs and updates the indicator.
To view advanced settings, select
settings. Changing wireless LAN advanced settings is not
recommended.

Data call

Select User defined or Unlimited
period after which data call connections automatically end
When available
When needed, the
is displayed
Show WLAN availability to
Options > Advanced
to define the time-out
123