Sony DCR-TRV720 Operating Instructions Manual page 58

Dubbing a tape
Using the i.LINK cable (DV connecting cable)
Simply connect the i.LINK cable (DV connecting cable) (not supplied) to
DV IN/OUT and to DV IN/OUT of the DV products. With digital-to-digital
connection, video and audio signals are transmitted in digital form for high-quality
editing. You cannot dub the screen indicators.
(1) Insert a blank tape (or a tape you want to record over) into the VCR, and insert
(2) Set the input selector on the VCR to DV IN if it is available. Refer to the
(3) Set the POWER switch to VTR.
(4) Play back the recorded tape on your camcorder.
(5) Start recording on the VCR.
When you have finished dubbing a tape
Press x on both your camcorder and the VCR.
Note on tapes that are not recorded in the Digital8
The picture may fluctuate. This is not a malfunction.
During playback of tapes recorded in the Hi8/standard 8 system
Digital signals are output as the image signals from the
You can connect one VCR only using the i.LINK cable (DV connecting cable).
See page 122 for more information about i.LINK.
During digital editing
You cannot use PICTURE EFFECT or DIGITAL EFFECT button function.
If you record playback pause picture via the DV IN/OUT jack
The recorded picture becomes rough. Also, when you play back the recorded pictures
on other video equipment, the picture may jitter.
58
the recorded tape into your camcorder.
operating instructions of your VCR for more information.
Refer to the operating instructions of your VCR for more information.
DV IN/OUT
: Signal flow
(not supplied)
system
DV S VIDEO LANC
DV IN/OUT
DV IN/OUT jack.