Cleanup - Titan 0524093 Owner's Manual

Cleanup

To clean:
1. Unplug the power cord.
Divide the spray gun. Push the Quick-Change
lever below the trigger (a), twist and separate
the front end from the turbine.
never hold the turbine under water or
immerse it into liquids.
2. Unscrew the container and remove.
Empty any remaining material back into the
material container.
Pre-clean the container and suction tube using
a brush and appropriate cleaning solution.
3. Clean the air vent (b) on the suction tube.
4. Pour a small amount of the appropriate
cleaning solution into the container. Attach
the container to the gun.
5. Connect front end assembly and turbine.
6. Plug in the power cord. Spray the cleaning
solution into a safe area.
note: If you are spraying into a waste container as
shown, have the spray pattern width set to narrow
to better direct cleaning solution into the waste
container.
Repeat the above procedure until the solvent
or water emerging from the nozzle is clear.
Continued on next page
English
Before you begin:
Start
When cleaning, use the appropriate cleaning solution (warm, soapy water
for latex materials; mineral spirits for oil-based materials)
ImpoRTanT: never clean nozzle or air holes in the spray gun with sharp
metal objects. Do not use solvents or lubricants containing silicone.
Special cleanup instructions for use with flammable solvents
Use extreme caution when using materials with a flashpoint
below 100° F (38°C):
• Always flush spray gun outside.
• Area must be free of flammable vapors.
• Cleaning area must be well-ventilated.
• Do not submerge turbine!
1
3
b
5
10
2
a
4
6
Empty waste
container