Setup - Titan 0524093 Owner's Manual

Setup

ImpoRTanT: Before connecting to the
power source, make sure that the power
cord voltage corresponds to the operating
voltage on the rating label. The unit must
be connected with a properly grounded
socket.
To set up:
1. Unscrew the material container from the
front end assembly.
2. Align the suction tube:
a. If you are going to be spraying in an
upward direction, the angled end of the
suction tube should be pointing toward
the rear of the gun.
b. If you are going to be spraying in a
downward direction, the angled end
of the suction tube should be pointing
toward the front of the gun.
3. Pour in the prepared coating material
(maximum 1 quart).
4. Carefully screw the material container
back onto the front end assembly.
5. Connect front end and turbine.
Plug in the power cord.
The sprayer is now ready for
operation.
Notice:
Start
Additional instructional items are located inside
the carry case. These items are meant to be
supplements to this instruction manual.
1
a
3
1 Quart
5
7
2
a
b
4
English