Maintenance - Titan 0524093 Owner's Manual

Maintenance

Air Filter:
ImpoRTanT: never operate the device with a dirty or missing air filter, as dirt
could be sucked in and affect the operation of the turbine and/or contaminate your
material. always check the air filter before starting work.
1. Unplug the power cord.
2. Turn the filter cover lock (a) to the unlock position. Remove the filter cover (b) and
filter (c).
3. Clean, blow out, or replace the air filter (c).
ImpoRTanT: Do noT clean the filter with any solvent. Use only warm, soapy water
to clean.
4. Replace the cleaned or new filter into the turbine. Make sure the filter is tucked
underneath the housing (d) on both sides of the turbine. Reattach the filter cover
and turn the filter cover lock to the lock position.
note: Make sure the tabs of the filter cover (e) snap into place on both sides of the
turbine (inset).
note: When replacing, use only Titan FlexSpray HandHeld filters.
Air Tube:
note: If paint has entered the air tube, proceed
as follows.
1. Pull the air tube (a) at the top from the
gun body. Screw off the valve cover (b).
Remove the valve seal (c). Clean all the
parts carefully.
ImpoRTanT: The air tube and valve seal (c)
are only solvent-resistant to a limited extent.
Do not immerse in solvent, only wipe.
2. Place the valve seal (c) in the valve cover
(b) with the pin facing into the tube.
note: Installing the valve seal into the valve
cover will be much easier if the valve cover is
inverted.
3. Turn the front end assembly upside down
and screw on the valve cover (with valve
seal inside) from underneath.
note: Turning the front end assembly upside
down will prevent the valve seal from falling out
of the valve cover during reinstallation.
4. Place the air tube on the valve cover and
on the nipple at the gun body.
Start Notice:
Review the information on this page to familiarize
yourself with the proper way to maintain your
paint sprayer.
1
a
b
c
3
13
d
e
2
c
b
4
English
b
a
c