Chip System - Yeti Cycles ASR C 2012 Owner's Manual

assembly
05.
Slide the swingarm over the main pivot bore,
using the grooves in the swingarm to properly
align over the bore.
07.
Prep the main pivot pin (shaft) and bolt (threads)
with grease. Install the female pivot pin from the
drive side of the bike. use a dead blow hammer
to push the pin into place. Once in place, install
and tighten the male pivot bolt with two 5mm
allen keys.
Torque to 115-125 in/lb.
22.
06.
use the fox guide pin to align and hold the
seatstays, dogbone, and shock together. use a
dead blow hammer to push the pin through the
above mentioned components.
08.
use the fox guide pin tool and a dead blow
hammer to install a 46.5mm female Ti bolt
through the seatstays, dogbone, and shock. use
a Ti male bolt prepped with blue loctite on the
non-drive side and tighten with two 5mm allen
keys.
Torque to 90-95 in/lb
01.
use a 2.5mm allen key to loosen the two
M4x9mm flat head bolts holding the QR insert
derailleur hanger in place. Remove the bolts and
the QR insert from the frame. Repeat the process
for the bolts and the non drive QR insert.
03.
Fit the 12MM non-drive insert into the groove on
the inside of the non-drive side chainstay. The
insert should be flush with the chainstay. next, fit
the non-drive 12mm cap through the chainstay
and into the insert from the outside of the non-
drive side chainstay. To finish, use a 2.5MM
allen key to attach the two dropout pieces to the
swingarm with two M4x10MM flat head bolts.
Prep the bolts with loctite and insert them into
the non-drive cap, through the swingarm and into
the insert.

chip system

02.
Fit the 12MM insert hanger into the groove on
the inside of the drive side chainstay. The hanger
should be flush with the chainstay. next, insert
the 12mm drive cap through the chainstay and
into the hanger from the outside of the drive
side chainstay. To finish, use a 3MM allen key to
attach the two dropout pieces to the swingarm
with two M4x15MM cap bolts. Prep the bolts with
loctite and insert them into the drive cap, through
the swingarm and into the hanger.
04.
Insert the M4x6MM custom cap bolt into the top
of the drive cap. This bolt will be used to set the
position of the Shimano 142x12MM axle. Refer to
Shimano specifications for exact instructions on
proper axle operations.
Torque for all chip system bolts: 15-20 in/lb
23.