Back to Contents Page
Installing System Options
Dell™ PowerEdge™ 6600 Systems Installation and Troubleshooting Guide
Fan Assembly Tray
Power Supplies
AC Power Module
Expansion Cards
Peripheral Riser Card
I/O Riser Card
This section describes how to install the following options:
Expansion cards
l
Memory upgrades
l
Microprocessor upgrades
l
This section also includes instructions for replacing:
Fans
l
I/O riser card
l
Peripheral riser card
l
Power supplies
l
System battery
l
Fan Assembly Tray
The system includes a fan assembly tray containing six fans. The fans can be removed as an assembly or individually.
CAUTION:
Before you perform these procedures, you must turn off the system and disconnect it from its power source. For more information, see
"Safety First—For You and Your
Removing the Fan Assembly Tray
1. Remove the back cover (see
2. Remove the front cover (see
3. Using the fan assembly tray handles, lift the assembly straight up to clear the chassis (see Figure 6-1).
Replacing the Fan Assembly Tray
NOTICE:
Ensure that the memory riser card handles and the peripheral riser card handles are in the closed position before installing the fan assembly
tray.
1. Align the alignment tabs with the slots in the chassis (see Figure 6-1).
2. Lower the fan assembly tray into the chassis.
3. Ensure that the fans are fully seated.
4. Replace the front cover (see
5. Replace the back cover (see
Figure 6-1. Removing the Fan Assembly Tray
System" in "Troubleshooting Your System."
"Removing the Back
Cover" in "Troubleshooting Your System").
"Removing the Front
Cover" in "Troubleshooting Your System").
"Replacing the Front
Cover" in "Troubleshooting Your System").
"Replacing the Back
Cover" in "Troubleshooting Your System").
Memory Riser Cards
Memory Modules
Microprocessor Tray
Microprocessors
System Battery