Dell PowerEdge 6600 Installation And Troubleshooting Manual page 60

3. Remove the back cover (see
4. Remove the front cover (see
5. Raise the following components to the service position:
Memory riser cards (See
l
Peripheral riser card (See
l
6. Remove the fan assembly tray (see
7. Rotate the microprocessor tray handles up until the tray is released from the front panel (see Figure 6-11).
Figure 6-11. Removing and Replacing the Microprocessor Tray
8. Slide the microprocessor tray out until the safety latches lock into place.
9. While pressing on the safety latches, pull the microprocessor tray straight out until the tray clears the chassis.
Replacing the Microprocessor Tray
NOTICE: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System Information document.
1. Slide the microprocessor tray into the chassis until the tray stops.
2. Lift the microprocessor tray handles up and push the tray forward slightly to engage the handle clasps.
3. Rotate the microprocessor tray handles down until the tray is secured to the front panel (see Figure 6-11).
4. Reseat the following components:
Peripheral riser card (See
l
Memory riser cards (See
l
5. Replace the fan assembly tray (see
6. Replace the front cover (see
7. Replace the back cover (see
8. Close the bezel (see "Closing the
Microprocessors
To take advantage of future options in speed and functionality, you can add additional microprocessors or replace installed microprocessors.
NOTICE: The additional microprocessors must be of the same type as the primary microprocessor. All microprocessors must also have the same L2 and
L3 cache sizes.
Each microprocessor and its associated cache memory are contained in a PGA package that is installed in a ZIF socket on the microprocessor board.
In a single-microprocessor system, the microprocessor must be installed in the CPU1 socket.
"Removing the Back Cover" in "Troubleshooting Your System").
"Removing the Front Cover" in "Troubleshooting Your System").
"Removing the Memory Riser Cards.")
"Removing the Peripheral Riser
"Removing the Fan Assembly
"Replacing the Peripheral Riser
"Replacing the Memory Riser Cards.")
"Replacing the Fan Assembly
"Replacing the Front Cover" in "Troubleshooting Your System").
"Replacing the Back Cover" in "Troubleshooting Your System").
Bezel" in "Troubleshooting Your System").
Card.")
Tray").
Card.")
Tray").