Setting Up The Monitor; Attaching The Stand - Dell UltraSharpUP3216Q User Manual

Setting Up the Monitor

Attaching the Stand

NOTE: The stand is detached from the monitor when it is shipped from the
factory.
NOTE: This is applicable for a monitor with a stand. When any other stand
is bought, please refer to the respective stand setup guide for the set up
instructions.
To attach the monitor stand:
1. Remove the cover and place the monitor on it.
2. Fit the two tabs on the upper part of the stand to the groove on the
back of the monitor.
3. Press the stand till it snaps into its place.
Connecting Your Monitor
WARNING: Before you begin any of the procedures in this section, follow
the Safety Instructions.
To connect your monitor to the computer:
1. Turn Off your computer and disconnect the power cable.
2. Connect the black HDMI cable or the DP (DisplayPort) cable to the
corresponding video port on the back of your computer.
Do not use all the cables on the same computer.
Use all of the cables only when they are connected to different
computers with appropriate video systems.
22  Setting Up the Monitor