Setting Up The Monitor; Attaching The Stand - Dell Thunderbolt UltraSharp 34 User Manual

Setting up the monitor

Attaching the stand

NOTE: The stand assembly is not pre-installed when the monitor is
shipped from the factory.
NOTE: The following instructions are applicable only for the stand that
was shipped with your monitor. If you are attaching a stand that you
purchased from any other source, follow the setup instructions that
were included with the stand.
To attach the monitor stand:
1. Remove the stand riser and stand base from the packaging cushion.
NOTE: The image is for the purpose of illustration only. The appearance
of the package cushion may vary.
2. Insert the stand base blocks fully into the stand slot.
3. Lift the screw handle and turn the screw clockwise.
4. After fully tightening the screw, fold the screw handle flat within the recess.
Setting up the monitor
│
43