Professional Installation Instructions - Dell Edge Gateway 5000 Series Installation And Operation Manual

WARNING: When installing the Power Module, use a cable appropriate
for the load currents: 3-core cable rated 15 A at 90 °C (194 °F)
minimum, which conform to either IEC60227 or IEC 60245. The
Gateway accepts cables of 14 AWG minimum.
WARNING: Before installing that all of three power inputs (Terminal
Block/Power Jack/Battery Input) in power module shall be protected
by the 20 A fuses or circuit-breakers(over current protection device) in
front of this system.
WARNING: The system is for installation in a suitable industrial
enclosure (provides electrical, mechanical and fire hazard protection).
WARNING: The core module only can be wall mounted (without the
need for an additional enclosure)
WARNING: Only Sealed Lead Acid (SLA) battery rated 50Ah (or less)
shall be used

Professional installation instructions

Installation personnel
This product is designed for specific applications and needs to be installed by
qualified personnel with RF and regulatory related knowledge. The general
user shall not attempt to install or change the setting.
Installation location
The product shall be installed at a location where the radiating antenna is kept
20 cm from nearby persons in its normal operation condition in order to meet
regulatory RF exposure requirements.
External antenna
Use only the antenna(s) which have been approved by the applicant. Non-
approved antenna(s) may produce unwanted spurious or excessive RF
transmitting power which may lead to a violation of FCC/IC limits and is
prohibited.
Installation procedure
Please refer to user's manual for the detail.
WARNING: Please carefully select the installation position and make
sure that the final output power does not exceed the limits set forth in
relevant rules. The violation of these rules could possibly lead to
serious federal penalties.
11