Configuring The Linux Iscsi Initiator - Dell QMD8262-k User Manual

3–Adapter Management Applications
General Management with QConvergeConsole
d.
e.
f.
9. On the options menu that appears, select 3, Save changes and reset HBA
(if necessary).
10. At the prompt for both ports, type Yes.
11. To return to the Converged Network Adapter (CNA) iSCSI Configuration
menu, type P and press ENTER, and then type P and press ENTER again.
12. On the Converged Network Adapter (CNA) iSCSI Configuration menu,
select 4, Target Configuration.
13. Select the same Converged Network Port you selected in
14. Select 6, Add a Target.
15. Complete the interactive list of settings as follows:
a.
b.
c.
d.
16. On the options menu that appears, select 12, Save Target/CHAP Changes.
The iSCSI initiator is now configured to connect to the iSCSI target.

Configuring the Linux iSCSI Initiator

Use the QConvergeConsole CLI to configure the iSCSI initiator for Linux.
To configure a Linux iSCSI initiator:
1. Access the QConvergeConsole CLI by typing qaucli in a terminal window.
2. On the QConvergeConsole CLI Main Menu, select 2, Adapter
Configuration.
3. On the Adapter Type Configuration Selection menu, select 1, CNA
Configuration.
4. On the Converged Network Adapter (CNA) Protocol Type Selection menu,
select 1, CNA iSCSI Configuration.
5. On the Converged Network Adapter (CNA) iSCSI Configuration menu,
select 3, Port IP Settings.
IP_Subnet_Mask [0.0.0.0]: Type the appropriate subnet mask, and
then press ENTER.
IP_Gateway [0.0.0.0]: Press ENTER to accept the default.
Enable IPv6 [off]: Press ENTER to accept the default.
IPv6 Target? [off]: Press ENTER to accept the default.
TGT_iSCSI_Name [ ]: Type the iSCSI Qualified Name (IQN) of the
iSCSI target to connect to and then press ENTER.
TGT_Port [3260]: Press ENTER to accept the default.
TGT_TargetIPAddress [0.0.0.0]: Type the IP address of the target
and then press ENTER.
66
Step 6.
CU0354602-00 L