Qconvergeconsole Cli - Dell QMD8262-k User Manual

4–Switch Independent Partitioning
Switch Independent Partitioning Setup and Management Options
6. Click the down arrow next to any of the offload fields provided to change its
value to Enabled or Disabled.
7. Select one of the following command buttons to apply or cancel any changes:




QConvergeConsole CLI

The QConvergeConsole CLI is a management utility that centralizes management
and configuration of QLogic adapters within the entire network (LAN and SAN).
You can use the QConvergeConsole CLI tool in either interactive or non-interactive
mode to configure and manage QLogic adapters installed on either Linux or Windows
host servers.
This section outlines the steps for setting up NIC partitions using the
QConvergeConsole CLI in interactive mode. The displayed commands apply to
both Linux and Windows operating systems.
NOTE
Throughout this section, the terms NIC partitioning and NPAR are
synonymous with Switch Independent Partitioning, and NIC partition is
synonymous with switch-independent partition.
For procedures on installing and starting this management tool, refer to the
QConvergeConsole CLI User's Guide.
Save–Saves changes displayed on the screen.
Restore Settings–Restores the default settings.
Cancel–Cancels any changes made to this screen before you saved
them.
154 CU0354602-00 L