Dell QMD8262-k User Manual page 232

5–Boot Configuration
iBFT Boot Setup
2. Select System BIOS Settings, then select Boot Settings, then select BIOS
Boot Settings, and then select Hard-Disk Drive Sequence, as shown in
Figure
3. In the pop-up window, use the UP ARROW and DOWN ARROW or
the + and – buttons to move the iSCSI target to the top of the list, as
shown in
Partition 3). Then click OK.
5-34.
Figure 5-34. Selecting iSCSI Boot Sequence
Figure 5-35 (where the iSCSI target is configured on Port 1,
Figure 5-35. Setting the iSCSI Boot Sequence
217 CU0354602-00 L