Dell QMD8262-k User Manual page 180

4–Switch Independent Partitioning
Switch Independent Partitioning Setup and Management Options
3. Use the Configure Function dialog box to set the minimum and maximum
bandwidth percentages, New Minimum BW and New Maximum BW (see
Figure
4. If needed, select the Make settings permanent check box to retain the new
settings.
5. Click OK to save your changes.
4-30).
Figure 4-30. Entering New Bandwidth Values
NOTE
ETS only specifies the division of bandwidth between FCoE and
non-FCoE traffic. It does not specify the bandwidth allocated to the NIC
or iSCSI partitions. When the switch sets ETS values, the ETS
bandwidth parameters take precedence. The FCoE partition is
allocated the bandwidth specified for FCoE in the ETS parameters.
The non-FCoE bandwidth is divided between the NIC and iSCSI
partitions in the proportion specified by the Switch Independent
Partitioning management user interface. In other words, when ETS is
in effect, the NIC and iSCSI bandwidth values specified by the Switch
Independent Partitioning management UI are no longer a percentage
of the total bandwidth. Instead, they are a percentage of the non-FCoE
bandwidth.
NOTE
If you do not select this option, the bandwidth values revert to the
default settings after you reboot the host server.
165 CU0354602-00 L