Dell QMD8262-k User Manual page 115

3–Adapter Management Applications
Windows Management Applications
Command
-nL
--noIntLP
-nH
--noHw
-nS
--noLinkSt
-h
--help
a All commands must be prefaced by qaucli -pr nic -qldiag. For example, to view the help,
issue the following commands:
qaucli -pr nic -qldiag --help
For every test performed, the diagnostic utility shows the following data:
 Total number of attempts
 Number of successful completions
 Number of failures
You can either perform all tests in succession or perform only specific tests
specified by the preceding command-line parameters.
You can run additional diagnostics in the CLI as listed in the following table. To
determine the cna_port_inst, issue the qaucli -nic –i command as
shown in
Table 3-8. Running Windows Diagnostic Tests in the CLI
Test Type
External
qaucli -nic -extloopback <cna_port_inst> <tests_num> <on_error>
Loopback
where <tests_num> specifies the number of tests, 1–65535, and <on_error> is
either 0=Ignore or 1=Abort.
NOTE: This test requires a pass-through module to be configured for both ports. Test runs
between two ports. Single port loopback is not supported.
Flash
qaucli –nic –testflash [cna_port_inst]
Hardware
qaucli –nic –testhw [cna_port_inst]
Internal
qaucli -nic -intloopback <cna_port_inst> <tests_num> <on_error>
Loopback
where <tests_num> specifies the number of tests, 1–65535, and <on_error> is
either 0=Ignore or 1=Abort.
Interrupt
qaucli –nic –testinterrupt [cna_port_inst]
Table 3-7. Diagnostic Test Commands (Continued)
a
No internal loopback test (combine –D or –a)
No hardware test (combine –D or –a)
No link status test (combine –D or –a)
View help text
Table 3-8.
Description
Command
100 CU0354602-00 L