4–Switch Independent Partitioning
Switch Independent Partitioning Setup and Management Options
Configure Switch Independent Partitioning
You can use the NIC Partition Management tab in the device properties page to
enable Switch Independent Partitioning and configure the 10GbE physical port
into a multifunction storage and networking port.
To set up Switch Independent Partitioning on a QLogic adapter port:
1.
Log in to the server that contains installed QLogic adapters.
2.
Open the Server Manager and select Diagnostics, then select Device
Manager, and then select Network Adapters.
3.
Right-click on the first QLogic 10GbE 2P <model> device and select
Properties from the shortcut menu (see
Figure 4-25. Selecting Properties from the Shortcut Menu
Figure
160
4-25).
CU0354602-00 L