Switch Independent Partitioning Configuration Parameters And Setup Tools - Dell QMD8262-k User Manual

4–Switch Independent Partitioning
Switch Independent Partitioning Setup
Switch Independent Partitioning Configuration Parameters
and Setup Tools
Table 4-7
available management tools.
Table 4-7. Switch Independent Partitioning Configuration Parameters and Setup Tools
Tools/Configurable
Switch Independent
Partitioning Parameters
Dell System Setup,
Lifecycle Controller,
or other HII browser
QLogic NIC OptionROM
(Hot Key CTRL+Q during
POST)
QLogic QConvergeConsole
GUI/CLI for supported
Windows and Linux operating
systems
QLogic Windows Device
Manager–NIC Property Page
QLogic QConvergeConsole
Plug-ins for vSphere
These changes require system reboot to take effect. Refer to
a
b For FCoE, the DCBX/ETS negotiated bandwidth overwrites the manually configured bandwidth.
c For FCoE, the DCBX/ETS negotiated bandwidth overwrites the manually configured bandwidth.
identifies which parameters you can configure using each of the
Function Minimum Bandwidth
Type
a
Yes Yes, configurable
Yes Yes, configurable
Yes Yes, configurable but only
for NIC partitions, not for
storage (iSCSI/FCoE)
partitions
Yes Yes, configurable but only
for NIC partitions, not for
storage (iSCSI/FCoE)
partitions
Yes Yes, configurable but only
for NIC partitions, not for
storage (iSCSI/FCoE)
partitions
b
(Range 0–100%)
Table 4-6 for available function type options of each partition.
174
Maximum Bandwidth
(Range 0–100%)
Yes, configurable
Not configurable, read only
Yes, configurable but only
for NIC partitions, not for
storage (iSCSI/FCoE)
partitions
Yes, configurable but only
for NIC partitions, not for
storage (iSCSI/FCoE)
partitions
Yes, configurable but only
for NIC partitions, not for
storage (iSCSI/FCoE)
partitions
CU0354602-00 L
c