Replacing The Display Assembly - Dell Vostro 1710 Service Manual

NOTICE: Ensure that the antenna cables do not get caught beneath the plastic tabs on the palm rest.
10. Lift the antenna cables from beneath the tabs on the palm rest and slide the antenna cable out from underneath the
palm rest.
11. Lift the display assembly out of the computer.
1 display cable 2 display assembly
3 antenna cables

Replacing the Display Assembly

CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your
computer.
This procedure assumes that you have completed the removal procedure
1. Align the display hinges with the holes in the base of the computer, then lower the display into place.
NOTICE: Ensure that the display cable and antenna cables are properly routed and secured beneath the
plastic tabs on the palm rest.
2. With the computer facing top side up, replace in sequential order the three numbered M2.5 x 5-mm screws that secure
the base of the display assembly.
3. Route the antenna cables beneath the plastic tabs on the palm rest.
4. Slide the antenna cables through the hole in the palm rest and the base of the computer.
5. Connect the display cable to the display cable connector on the system board.
6. Replace the screw that secures the display cable to the base of the display assembly.
7. In sequential order, replace the four M2.5 x 5-mm screws in the base of the display assembly.
8. Replace the keyboard (see Replacing the Keyboard).
Removing the Display Assembly.