Back to Contents Page
Display
Dell™ Vostro™ 1710
Service Manual
Display Assembly
Display Bezel
Display Panel
Display Cable
Camera and Microphone Assembly
Display Assembly
Removing the Display Assembly
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your
computer.
1. Follow the instructions in
2. Disconnect the antenna from the WLAN card (see
3. With the computer facing bottom side up, remove the two M2.5 x 8-mm screws that attach the display assembly to
both corners of the computer.
4. With the computer facing bottom side up, remove the M2.5 x 5-mm screw located at the bottom of the battery bay
near the edge of the computer.
5. Remove the hinge cover (see
6. Remove the keyboard (see
7. With the computer facing top side up, remove in sequential order the three numbered M2.5 x 5-mm screws from the
base of the display assembly.
8. Remove the screw that secures the display cable to the base of the display assembly.
9. Disconnect the display cable from the display cable connector on the system board.
Before Working on Your
Removing the Hinge
Removing the
Keyboard).
Computer.
Removing a WLAN
Card).
Cover).